Available Model Types

2006 Ford F-250 Dana 60 steering knuckle, scan only

Pitman arm from a 1999-2004 Jeep Grand Cherokee WJ

Front unit bearing from a 1999-2004 Jeep Grand Cherokee, 5x5 bolt pattern

Wheel spindle used on Twin Traction beam Ford F-250 trucks through the 1980's

Stock throttle body from the Jeep 4.7 V8

Throttle body from a Jeep 4.0 inline 6 engine, with TPS and IAC sensors installed

Belt driven york AC compressor, commonly converted into air pumps

Dana 30 steering knuckles from a 1998 Jeep Cherokee XJ

Intake manifold off a 1995 Jeep Cherokee XJ

Stub shaft from a Kingpin Ford Dana 60

Wheel hub from a front Ford kingpin Dana 60

Differential cover for a Dana 60. This is from a 1987 Ford F-350 high pinion dana 60

4-53 supercharger off a 212 cubic inch detroit 2 stroke diesel

Eaton M90 supercharger, from a Pontiac car

Differential cover from a Dana 30; 2000 Jeep Grand Cherokee (but applies to most/all earlier and later models as well)

Sterling 10.25" Differential Cover, the rear axle from a 1987 Ford F-350

Unit Bearing from a 1999-2004 Ford F-250/F-350 Super Duty

6l80E Transmission - 4wd with deeper truck pan